Template:X-Series/Installation/X-LSQ-EC

Dust Cover Installation and Removal

The {{{Device}}} stage comes with a removable dust cover. Temporary removal is required to access stage mounting holes and to re-lubricate the linear bearings.

• 

  Loosen the two set screws on the motor end plate using a 1.5 mm hex key.

• 

  Remove the two M3 screws on the end of the LSQ device.

• 

  Slide the dust cover and spacer plate out from the end plate and through the carriage. The carriage top can remain in place or be removed.

• 

  To reinstall the dust cover, simply slide the cover back into place and tighten the two M3 set screws on the motor end plate using a 1.5 mm hex key.

• 

  Slide the spacer plate back under the end of the dust cover and align the M3 holes. Reinstall the two M3 screws using 2 mm hex key.

• 

  If the stage top was removed, install the four M3 x 16 mm screws. Make sure the stage top edge is aligned to the carriage edge. Tighten screws to 1.3 Nm using a 2.5 mm hex key.