T-Series/Commands/Set Knob Disabled Mode
Set Knob Disabled Mode - Cmd 107
Warning: This is an "include" page. As such, its contents may be included in multiple other pages. To see a list of all pages that include this page, click on "What links here" in the bottom left navbar. If you make changes to this page, be sure that your changes are appropriate to all pages on which this content will be included. You are also encouraged to review our Zaber Wiki Editing Guidelines. This header will not be included in other pages.
| Instruction Name | Set Knob Disabled Mode |
|---|---|
| Applies to | A-Series and X-Series motorized devices |
| Firmware Version | 6.xx |
| Command Number | 107 |
| Command Type | Setting |
| Command Data | Knob Disabled Mode |
| Reply Data | Knob Disabled Mode |
| Safe to retry? | Yes |
| Returns Current Position? | No |
| Persistence | Non-Volatile |
| Summary | Enables or disables manual movement control. |
Use this command to disable knob functionality. When the knob is disabled, all knob turns and depresses are ignored.
- 0 - Knob Enabled (Default)
- Knob functions normally.
- 1 - Knob Disabled
- Knob interaction is ignored.
This setting is identical to bit 3 of Set Device Mode (Cmd 40). Changes to either this setting or the device mode will be reflected in the other.
This setting is stored in non-volatile memory and will persist after power-down or reset.