T-Series/Commands/Set Knob Direction
Set Knob Direction - Cmd 108
Warning: This is an "include" page. As such, its contents may be included in multiple other pages. To see a list of all pages that include this page, click on "What links here" in the bottom left navbar. If you make changes to this page, be sure that your changes are appropriate to all pages on which this content will be included. You are also encouraged to review our Zaber Wiki Editing Guidelines. This header will not be included in other pages.
| Instruction Name | Set Knob Direction |
|---|---|
| Applies to | A-Series motorized devices |
| Firmware Version | 6.xx |
| Command Number | 108 |
| Command Type | Setting |
| Command Data | Knob Direction |
| Reply Data | Knob Direction |
| Safe to retry? | Yes |
| Returns Current Position? | No |
| Persistence | Non-Volatile |
| Summary | Changes direction of movement when knob is turned. |
Use this command to reverse the device movement direction when the knob is turned.
- 0 - Normal (Default)
- Clockwise knob turn results in movement in the positive direction.
- 1 - Reversed
- Clockwise knob turn results in movement in the negative direction.
This setting is identical to bit 9 of Set Device Mode (Cmd 40). Changes to either this setting or the device mode will be reflected in the other.
This setting is stored in non-volatile memory and will persist after power-down or reset.
