T-Series/Commands/Set Auto-Reply Disabled Mode
Set Auto-Reply Disabled Mode - Cmd 101
Warning: This is an "include" page. As such, its contents may be included in multiple other pages. To see a list of all pages that include this page, click on "What links here" in the bottom left navbar. If you make changes to this page, be sure that your changes are appropriate to all pages on which this content will be included. You are also encouraged to review our Zaber Wiki Editing Guidelines. This header will not be included in other pages.
| Instruction Name | Set Auto-Reply Disabled Mode |
|---|---|
| Applies to | A-Series and X-Series motorized devices |
| Firmware Version | 6.xx |
| Command Number | 101 |
| Command Type | Setting |
| Command Data | Auto-Reply Disabled Mode |
| Reply Data | Auto-Reply Disabled Mode |
| Safe to retry? | Yes |
| Returns Current Position? | No |
| Persistence | Non-Volatile |
| Summary | Disables all command auto-replies from the device. |
Use this command to disable auto-reply. When the auto-reply is disabled, device will only reply to “Return” commands.
- 0 - Auto-Reply Enabled (Default)
- Device replies to all commands
- 1 - Auto-Reply Disabled
- Device only replies to "Echo", "Read", "Renumber", and "Return" commands
This setting is identical to bit 0 of Set Device Mode (Cmd 40). Changes to either this setting or the device mode will be reflected in the other.
This setting is stored in non-volatile memory and will persist after power-down or reset.