T-Series/Commands/Set Active Register

Set Active Register - Cmd 6

Warning: This is an "include" page. As such, its contents may be included in multiple other pages. To see a list of all pages that include this page, click on "What links here" in the bottom left navbar. If you make changes to this page, be sure that your changes are appropriate to all pages on which this content will be included. You are also encouraged to review our Zaber Wiki Editing Guidelines. This header will not be included in other pages.

Instruction Name	Set Active Register
Applies to	A-Series devices
Firmware Version	6.xx
Command Number	6
Command Type	Setting
Command Data	Register Address
Reply Data	Register Address
Safe to retry?	Yes
Returns Current Position?	No
Persistence	n/a
Summary	Sets the active register.

This command sets the address of the active register. When a device receives a Write Register (Cmd 7) command, data is written to the active register.

NOTE: This command is meant for Zaber's internal use. Do not use this command unless directed to by Zaber technical support.