T-Series/Commands/Reset/A-Series Motorized Devices

Special Note

For firmware 6.16 and above, after the Reset (Cmd 0) command is sent the device will wait to reset until the communication lines have been idle for 500ms. For firmware 6.15 and below, after the Reset (Cmd 0) command is sent the device will reset as soon as the communication lines are idle.

The position of the device will be lost upon reset. If it is important to keep the same position, Park the stage before resetting/powering down and Unpark the stage afterwards to recover the position settings (See Set Park State (Cmd 65) command).

All non-volatile settings (i.e. Device Number, Target Velocity, etc.) are saved and are not affected by reset or power-down.