T-Series/Commands/Manual Move
Jump to navigation
Jump to search
Manual Move - Cmd 11
Warning: This is an "include" page. As such, its contents may be included in multiple other pages. To see a list of all pages that include this page, click on "What links here" in the bottom left navbar. If you make changes to this page, be sure that your changes are appropriate to all pages on which this content will be included. You are also encouraged to review our Zaber Wiki Editing Guidelines. This header will not be included in other pages.
| Instruction Name | Manual Move |
|---|---|
| Applies to | A-Series and X-Series motorized devices |
| Firmware Version | 6.xx |
| Command Number | 11 |
| Command Type | Reply |
| Command Data | n/a |
| Reply Data | Position |
| Safe to retry? | Yes |
| Returns Current Position? | Yes |
| Persistence | n/a |
| Summary | A knob manual move in Displacement mode has completed. |
Manual Move Tracking has been enabled (see Set Manual Move Tracking Disabled Mode (Cmd 116)) and the device has been moved manually (the knob is turned) in displacement mode.
For firmware 6.13 and below, Set Manual Move Tracking Disabled Mode is ignored and this message is always sent.