T-Series/Commands/Set Slip Tracking Period
From ZaberWiki
Set Slip Tracking Period - Cmd 119
Warning: This is an "include" page. As such, its contents may be included in multiple other pages. To see a list of all pages that include this page, click on "What links here" in the bottom left navbar. If you make changes to this page, be sure that your changes are appropriate to all pages on which this content will be included. You are also encouraged to review our Zaber Wiki Editing Guidelines. This header will not be included in other pages.
| Instruction Name | Set Slip Tracking Period |
|---|---|
| Applies to | A-Series motorized closed-loop devices |
| Firmware Version | 6.xx |
| Command Number | 119 |
| Command Type | Setting |
| Command Data | Tracking Period in ms |
| Reply Data | Tracking Period in ms |
| Safe to retry? | Yes |
| Returns Current Position? | No |
| Persistence | Non-Volatile |
| Summary | Sets the update interval between Slip Tracking messages. |
Use this command to configure the interval between each Slip Tracking responses.
- 0 - Slip Tracking Disabled
- Set to 0 to turn off slip tracking
- 1 to 65535 - Slip Tracking Enabled
- Interval between Slip Tracking messages, in units of ms.
This setting is stored in non-volatile memory and will persist after power-down or reset.
